Audio

Setting up a wedge monitor on stage

1. For use when kids sing on stage with music from the computer
2. Change the Output on Audio Mixing Board
   1. Press the Outputs button – located below the LED screen
   2. Make sure you are on the IDR Mix Rack tab
   3. Select the H-2 Output port by touching the screen
   4. Change the ‘Select Output Source’ from Mains to Mono Aux
   5. Make sure the ‘Channel Number’ is 2 WDGR – which is Wedge Monitor Right
   6. Save the new settings by touching ‘Apply’
3. Change the Output cable on the Mixing Rack behind stage
   1. Find the H-2 output port on the mixing rack – Monitor 4 XLR cable should be in that port
   2. Remove Monitor 4 and replace it with Monitor 6 XLR cable
4. Hook up a wedge monitor on stage
   1. Get a wedge monitor from the green room
   2. Place it by the floor box on stage which has Monitor 6 port in it
   3. Connect the Monitor 6 XLR cable in the floor box to the wedge monitor
   4. Connect A/C power to the wedge Monitor – A/C outlet is in the floor box
5. Now the wedge monitor should be able to be controlled by the WDGR Monitor channel on the board.
6. When finished using the wedge monitor put everything back to the way it was:
   1. Disconnect the wedge monitor on stage and put it back in the green room
   2. Replace the Monitor 6 XLR cable with the Monitor 4 XLR cable on the mixing rack
   3. Change the H-2 Output on the board back to Mains Output Source and Channel 2 R