"Ask Me Anything": Ten Responses To Your Questions About Peugeot 308 Key Fob

peugeot partner replacement key 308 Key Fob Replacement

peugeot 208 key fob not working's 308 might be catching on a bit however it's still appealing. It might not be the plushest car in its class - a Ford Focus or Volkswagen Golf will protect you from road imperfections, but it's still a pleasant and a civilized driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 108 Key cover 308 key fobs. The following tips can assist whether the issue is constant or intermittent.

Water Damage

If you accidentally drop your key fob into a puddle, or if it gets wet while kayaking canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to avoid this from happening is to always keep it in a dry bag whenever you're outside or performing activities in which the fob may be exposed to excessive amounts of water.

You'll also want to make sure that the fob is dry before opening it up and using it again. If you detect any smells emanating from the fob like an industrial-like liquid smell or windshield washer fluid, it's another indication that it's submerged in water.

A wet circuit may cause the battery's power to be depleted or even explode. If you're able fish the 308 key fob from the body of water it was stuck in, flip the button side down and shake out as much water as you can before opening the case. After you open it, take out the battery, and then clean the circuit board using the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not work include a dead coin-cell battery or receiver module issue signal interference, or a defective chip. If none of these is the cause, you can try resetting the system by disconnecting the 12 volt battery for around 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system which allows the driver to start the car from afar, warming up or cooling down the vehicle prior to getting in. This feature is very beneficial especially during the cold winter months. However, sometimes the remote start system stops functioning due to a variety of reasons, such as an unresponsive coin battery.

A coin-shaped battery found inside the key fob has a life span of two to four years, depending on how often it is used and the location where it was purchased. The date of use is usually written on the package or written in the manual.

If the key fob is no longer working after exposure to clean tapwater, remove the battery and clean the electronic chip using the help of a paper towel that has been soaked with isopropyl ethanol. Then, dry the chip thoroughly before replacing. If the key fob was exposed to salty or soapy water, it may have caused the chip to be damaged. It is recommended to replace it.

If you're not certain that the battery is not working properly you can check its voltage using an instrument set to the car's voltage range. Connect it to the terminals for minus and plus. The voltage should range from 12-13 volts but if it's lower, then the battery needs to be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.

Faulty Receiver Module

If you don't see "Key Detected" message, it could mean that your receiver module is not working properly. It's the part that transmits an indication to the car when your key fob is activated that also acts as an immobiliser and prevents it from starting unless the correct key is used.

This could be due to a range of factors including water damage or simply ageing. If the electronic chip within your Peugeot 308 keyfob is damaged due to dirty tap water it could be due to the fact that the keyfob was contaminated with it. In this scenario, you'll need to take the device apart and clean it thoroughly with isopropyl alcohol, or electronic cleaner. Once the battery has dried, you can try again.

If the issue persists, it's probably a good idea to visit an area Peugeot specialist or locksmith. They can employ a diagnostic tool in order to pinpoint the issue and then fix it.

It is stressful to lose your Peugeot car key. However, a reputable auto locksmith can fix the issue in a matter of minutes. They can program your vehicle and cut a new working key for you. Click here to find a locksmith near you.

Faulty electronic chip

The electronic chip in the peugeot car key replacement cost 308 key fob is a critical part in the remote control system. If it becomes damaged, your car might not start, or you could get a message saying "anti-theft active". In this situation the only option is to replace the key. Fortunately, auto locksmiths with experience can offer the service within the shortest period of time.

The chip inside your peugeot key cutting 308 key fob can become faulty due to water damage, sweat dirt, or other reasons. If your Peugeot 308 key fob has been exposed to soapy water, clean it right away. You can wipe the electronic component using paper towels soaked with isopropyl Alcohol. The battery must then be allowed to dry completely.

Radio interference can cause the key fob to stop functioning. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects close to the vehicle. It is recommended that you visit a Peugeot dealer if you encounter this issue.

The Peugeot Key Fob 207/308 is fragile and requires special attention. It is imperative not to drop or throw the key fob. If you lose it, try to locate it as quickly as you can. You can reset the onboard computer by disconnecting the battery for a couple of minutes. Make sure you disconnect the negative cable first, and then the positive.